Description

The value of the product:

• For internal works
• The thickness of the layer is up to 3 mm
• Easy to apply and sand
• Does not crack
• Vaporable

Recommended uses:
Using for the partial and continuous puttying of the surfaces, in order to equalize minor roughness and defects with the thickness up to 3 mm before applying the finish coat inside the premises (painting, decorative plasters, gluing wallpaper, etc.). Do not use the product in the places with high humidity, or on the surfaces, which are always contact with water!

The mode of application:
Surface preparation:

• The surface must be clean, dry, strong and free from grease
• The surfaces previously coated with chalk, glue, lime or silicone paints, must be cleaned from the old coating completely
• Mold or fungus must be removed with the help of the Biosecurity Agent “TR-25 bio” TM TRIORA prof
• For high-quality preparation of the surface it must be primed, with the universal acrylic primer TM TRIORA or Priming concentrate 1/5 TM TRIORA
• Intensively absorbing surfaces (aerated concrete, gypsum), as well as surfaces that crumble, should be primed with the strength primer with the deep penetration by TM TRIORA

Application:

• The putty must be mixed before applying
• Now putty is ready for using
• Must be applied with the help of a spatula or spray with the layer thickness up to 3 mm
• Before final finishing, the surface must be sanded with the fine sanding pad and then primed in 1 coat. The dust must be removed from the surface to improve the adhesion of the following material

Storage, transportation and disposal:
Keep out of children’s reach. In case of contact with eyes, rinse immediately with clean water. Protect from frost. Keep at dry and cool place at a temperature not lower than + 5°C and not higher than + 35°C, protected from direct sunlight.
Closed containers with residues have to be recycled municipal waste collection sites.