Description

The value of the product:

• Using for acrylic and silicone putties
• Contains quartz filling
• Creates a rough structure
• Has an excellent adhesion to the surface
• Permeable – the surface “breathes”

Recommended uses:
Using for application to the concrete, plaster, cement-lime, cement-sand, brick, gypsum plasterboard, as well as surfaces previously painted with water-dispersion paints

The mode of application:
Surface preparation:

• The surface must be clean, dry, strong and free from grease. The surfaces previously coated with chalk, glue, lime or silicone paints should be cleaned from these coating completely
• If there is mold or fungus on the surface, they have to be removed with the help of BIO-protective agent TM TRIORA
• Fresh cement plasters could be processed no earlier than 28 days
• For the intensively absorbent surfaces (aerated concrete, gypsum) and crumbling surfaces, use a Strengthens primer with the deep penetration by TM TRIORA

Method of application:

• Mix thoroughly before using
• Could be applied undiluted or, if it is necessary, diluted with the water to get good viscosity (but not more than 5% of water)
• Have to be applied only in one layer

Storage, transportation and disposal:
Keep out of children’s reach. In case of contact with eyes, rinse immediately with clean water. Protect from frost. Keep at dry and cool place at a temperature not lower than + 5°C and not higher than + 35°C, protected from direct sunlight.
Closed containers with residues have to be recycled municipal waste collection sites.